fbpx
jeep stickers

Installing custom jeep stickers

It can be challenging if you have no idea about how to install custom jeep stickers. Once you understand what to do, it becomes a walk in the park.

In this post, we will discuss how you can install custom jeep stickers from Zigpac. Furthermore, at the end of this, you should be able to install your best jeep stickers with ease.

What you needrequest quote from zigpac

To install these stickers (know more), you need the following:

  • Paper/masking tape
  • Water
  • Installation Squeegee
  • Paper towels
  • A pair of scissors

The process

Step 1: Take your jeep stickers out of the box

Of course, the first thing to do is to take out your stickers from the box. In the case that they were rolled in, you need to straighten them out first before you begin the installation. If you don’t do this, there is a chance of getting bubbles as you install.

request quote from zigpac

Step 2: Clean the surface

The best thing to do is pressure-wash your vehicle and make sure it is dry before you begin installing. In case you do not have the opportunity to do this, there is something else you can do.

Get some water and spray it over the surface you want to install your best jeep stickers on. The water should loosen up any dirt on the surface. Wipe the surface clean with a paper towel. Repeat the process till you are sure the surface is clean enough. Use a lot of water so you don’t scratch your paint off with the paper towel.

After drying up the surface, spray some denatured alcohol over it and wipe again with a paper towel. In addition, if you are wary about the alcohol damaging your paint, can make use of anything else you are comfortable with. The reason for this is to remove any leftover wax on the surface. Any of these impurities will keep the jeep stickers from holding to the surface.

best jeep stickers

Step 3: Placing your jeep sticker

Pick your graphic and place it over the clean surface. So, spread it over and make sure it flat to avoid any bubbles. Hold the sticker in place with tape. This tape should run down the middle vertically from your standpoint. This will make it easy for you to install.

Step 4: Separate the mask material from the back of the jeep sticker

With your sticker held in place by the tape, bend over one side and peel off the mask behind. This method is the hinge method. You should peel off the mask to the point where the tape holds then tear it off. You can tear it off by hand or with a pair of scissors.

Use the squeegee to smoothen the custom jeep stickers from Zigpac till you have covered the whole area. You can remove the tape and repeat the process for the other side of the sticker. After you have fixed the sticker, go over the surface with your squeegee one more time.

request quote from zigpac

Step 5: Remove the mask

Spray little water over the surface to help loosen the mask from the graphic. Finally, pick up one end of the mask and peel it off.

Conclusion

Yes, installing your jeep stickers is that easy. So, you can order custom jeep stickers from Zigpac where you have the best jeep stickers at affordable prices.

Leave a Reply

%d bloggers like this: